Fountain

The Fountain was originally intended to be a fireworks pattern reminiscent of a rocket going up and bursting in the sky, but the natural shape of the tree made it look more like water bubbling out of the ground. A little change in the template made it so that it looked like all the water was bubbling down the tree. The fountain has a total of 18 steps, each step running for about a quarter second. When the tree is in automatic cycle mode, the fountain runs 6 times before advancing to the next pattern.

Home

Tree 1.1

User Menu

Like it? Share it!

Tree 1.1

Step 14

Written by John Toebes

Step 14

Insert the USB jack. It goes on the back of the board. Bend the metal tabs on the case and solder them to the board.

Last Updated on Monday, 20 October 2008 04:23

Step 13

Written by John Toebes

Step 13

Insert the Red LEDs in the remaining spots below the Yellow LEDs that were put in last step. Carefully check to make sure that they are also flat.

Last Updated on Monday, 20 October 2008 04:22

Step 12

Written by John Toebes

Step 12

Insert the Yellow LEDs. These go below the Green LEDs and at the top of the board. Once again, pay attention to orientation and make sure that they are flat on the board.

Last Updated on Monday, 20 October 2008 04:21

More Articles...

«Start Prev12345678910Next End»

Page 3 of 11

Joomla! is Free Software released under the GNU/GPL License.