|
Written by John Toebes
|
| Step 2Insert the four 560 ohm resistors. They will have a color band of Green Blue Brown. Bend the leads at a 90 degree angle before inserting it in the board and remember to point the Gold band toward the top of the board so all the resistors will have the same look. Turn the board over, solder one end of each lead, turn it back over and ensure that they are all straight before turning over again, soldering the other lead and then trim. |
|
|
Last Updated on Sunday, 19 October 2008 04:02 |
|
|
Written by John Toebes
|
| Step 1Insert the two 10K ohm resistors. They will have a color band of Brown Black Orange. Bend the leads at a 90 degree angle before inserting it in the board and remember to point the Gold band toward the top of the board so all the resistors will have the same look. Turn the board over, solder one end of each lead, turn it back over and ensure that they are all straight before turning over again, soldering the other lead and then trim. |
|
|
Last Updated on Sunday, 19 October 2008 04:02 |
|
Written by John Toebes
|
What's in the KitBefore you get started, make sure that you have all the parts. They are grouped in plastic bags to make it easy to find the parts you need for each step. In addition, you will need a soldering iron, solder, screw driver, and a nice wire clippers. It isn't necessary, but a good wire forming tool makes it much easier to get a great looking tree.  |
|
Last Updated on Tuesday, 28 October 2008 03:51 |
|
|
|
|
|
|
Page 7 of 11 |
Tree 1.1
